BSMMR - U3700 SERIES FRESH LOOK SPRAY ENAMEL
- MSDS: BSMMR
- Manufacturer: UNITED COATINGS INC
- Product Name: U3700 SERIES FRESH LOOK SPRAY ENAMEL
- National Stock Number: 8010-00F031057
Product Identification
Product ID:U3700 SERIES FRESH LOOK SPRAY ENAMEL
MSDS Date:06/01/1992
FSC:8010
NIIN:00F031057
MSDS Number: BSMMR
Responsible Party
KANKAKEE, IL 60901
US
Emergency Phone: 800-621-1000
Info Phone: 815-935-1200
Preparer: TOM YATES
Cage: UNITD
Contractor
Telephone: 815-935-1200
Cage: UNITD
Ingredients
TOLUENE
CAS: 108-88-3
RTECS: XS5250000
Fraction By Weight: 34.6%
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
PROPANE
CAS: 74-98-6
RTECS: TX2275000
Fraction By Weight: 15%
OSHA PEL 1000 PPM
ACGIH TLV: SIMPLE ASPHYXIANT
BUTANE, N-BUTANE
CAS: 106-97-8
RTECS: EJ4200000
Fraction By Weight: 15-20%
OSHA PEL 800 PPM
ACGIH TLV: 1900 MG/CUM
ACETONE; DIMETHYL KETONE
CAS: 67-64-1
RTECS: AL3150000
Fraction By Weight: 8.9%
OSHA PEL 2400 MG/CUM
ACGIH TLV: 500 PPM
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
LIGHT ALIPHATIC NAPHTHA, VM & P NAPHTHA, LACOLENE *93/3*
CAS: 64742-89-8
Fraction By Weight: 5.9-9.1%
OSHA PEL 100 PPM
ACGIH TLV: 100 PPM
2-BUTOXYETHANOL (ETHYLENEGLYCOL MONOBUTYL ETHER), BUTYL
CAS: 111-76-2
RTECS: KJ8575000
Fraction By Weight: 2.5%
OSHA PEL 50 PPM (SKIN)
ACGIH TLV: 25 PPM (SKIN)
VINYL TOLUENE ALKYD RESIN *92-2*
CAS: 68309-54-6
Fraction By Weight: 8.9%
7.75 - 8.25
RTECS: 9999999WG
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: RESPIRATORY IRRITATION.
OVEREXPOSURE TO SOLVENTS MAY CAUSE PERMANENT BRAIN & NERVOUS SYSTEM
DAMAGE.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:INHALATION: DIZZINESS, NAUSEA, LOSS OF
CONSCIOUSNESS.
Medical Cond Aggravated by Exposure:ANY RESPIRATORY CONDITIONS.
First Aid
First Aid:INHALATION: REMOVE TO FRESH AIR. IF BREATHING HAS STOPPED,
USE MOUTH-TO-MOUTH. EYES: FLUSH W/WATER FOR 15 MINUTES. SKIN: WASH
W/SOAP & WATER, REMOVE CONTAMINATED CLOTHING. INGESTION: DON'T
INDUCE VOMI TING, CONSULT PHYSICIAN OR POISON CONTROL CENTER.
OBTAIN MEDICAL ATTENTION IN ALL CASES.
Fire Fighting
Flash Point Method:TCC
Flash Point: <100F
Extinguishing Media:CO2, DRY CHEMICAL, WATER FOG
Fire Fighting Procedures:WATER MAY BE USED TO COOL CONTAINERS TO
PREVENT BUSTING. IF WATER IS USED, FOG NOZZLES ARE PREFERRED. WEAR
GOGGLES, SCBA OR AIR MASKS.
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT, SPARKS, OPEN FLAMES.
EXPOSURE TO HEAT MAY CAUSE BUSTING OF AEROSOL CAN.
Accidental Release
Spill Release Procedures:VENTILATE AREA. AVOID BREATHING VAPORS. USE
SCBA OR AIR MASK FOR LARGE SPILLS IN CONFINED AREA. WIPE UP OR
ABSORB ON SUITABLE MATERIAL & SHOVEL UP. AVOID ALL PERSONAL
CONTACT.
Handling
Handling and Storage Precautions:CONTAINERS SHOULD BE GROUNDED WHEN
POURING. AVOID FREE FALL OF LIQUID. KEEP AWAY IGNITION SOURCES.
KEEP CONTAINER CLOSED WHEN NOT IN USE.
Other Precautions:DON'T STORE >120F. EMPTY CONTAINERS MAY CONTAIN
PRODUCT RESIDUE. DON'T CUT, PUNCTURE OR WELD ON OR NEAR CONTAINER.
ALL LABELED WARNINGS MUST BE OBSERVED UNTIL THE CONTAINER HAS BEEN
CLEANED OR RECONDI TIONED.
Exposure Controls
Respiratory Protection:WEAR APPROPRIATE, PROPERLY FITTED RESPIRATOR
DURING & AFTER APPLICATION.
Ventilation:REQUIRED FOR SPRAYING IN A CONFINED AREA. EQUIPMENT SHOULD
BE EXPLOSION PROOF.
Protective Gloves:REQUIRED
Eye Protection:SAFETY GLASSES
Other Protective Equipment:PROTECTIVE CLOTHING FOR PAINTING OPERATIONS.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING. DON'T
CONSUME FOOD OR BEVERAGE WHILE USING THIS PRODUCT.
Supplemental Safety and Health
INTENTIAL MISUSE BY DELIBERATELY CONCENTRATION & INHALING THE CONTENTS
MAY BE HARMFUL/FATAL.
Chemical Properties
Vapor Density:>1
Spec Gravity:0.86-1.06
Evaporation Rate & Reference:FASTER THAN ETHER
Solubility in Water:INSOLUBLE
Percent Volatiles by Volume:84-86
Stability
Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:HIGH TEMPERATURES, IGNITION SOURCES,
TEMPERATURES >120F
Hazardous Decomposition Products:NITROGEN OXIDES, CO2, CO, METAL OXIDES
Disposal
Waste Disposal Methods:DISPOSE IN CHEMICAL DISPOSAL AREA OR IN A MANNER
THAT COMPLIES W/LOCAL, STATE & FEDERAL REGULATIONS. DON'T
INCINERATE CLOSED CONTAINERS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.